budgie writes:

On 10 Nov 2004 08:47:57 -0500, Sam Goldwasser wrote:

I need to fab 50-100 small (1"x1"), double sided, plated through hole
PCBs. No special requirements. Soldermask desireable but not essential.
Cost is of course the issue. What I've found so far is around $300 for
a full feature service including separating the boards. I've done this
before without soldermask and uncut for something like $100-150 and might
do that again but would rather not have to use the bandsaw and files.

I've used http://www.custompcb.com for jobs like this.

Thanks. I just did it with them and was fine. They were very responsive
to questions and the quality seems decent. I wouldn't say it's super but
certainly adequate if you're not doing super fine pitch PCBs.

--- sam | Sci.Electronics.Repair FAQ Mirror: http://repairfaq.ece.drexel.edu/
Repair | Main Table of Contents: http://repairfaq.ece.drexel.edu/REPAIR/
+Lasers | Sam's Laser FAQ: http://repairfaq.ece.drexel.edu/sam/lasersam.htm
| Mirror Sites: http://repairfaq.ece.drexel.edu/REPAIR/F_mirror.html

Note: These links are hopefully temporary until we can sort out the excessive
traffic on Repairfaq.org.

Important: Anything sent to the email address in the message header is ignored.
To contact me, please use the Feedback Form in the FAQs.