On Sat, 11 Dec 2004 17:18:49 -0500, "RBM"
wrote:

I apologize for demeaning some of the replies, however there is usually a
right way and usually a wrong way to do most things. Because someone does
something wrong for many years,with no adverse consequences,doesn't make it
right. It may just make them lucky. Some folks would prefer not to play
Russian roulette, and just do the thing right from the beginning
"Kyle Boatright" wrote in message
...
Our pool has a design flaw (or maybe not, I've never paid much attention
to how other pools are done)..

Where the main drain line exits the ground and goes into the pump area,
there is a 4' or 6' length of PVC pipe that is exposed, and can't be
drained without draining the entire pool. The question is: How to freeze
protect this piece of pipe? Thermostat regulated heat tape and some wrap
on insulation? Build a box around it with a lightbulb inside? Maybe one
of those 1,000 watt ceramic heaters with a thermostat?

I'm in Atlanta, and our winters usually have a few days (or nights) of
sub-20 weather, with a rare plunge below 10, and the very rare plunge
below 0.

Suggestions appreciated.


Id accept your appology but you immediately turn into a smartass
again. How on earth is it that you figure leaving water at the regular
line is WRONG? Hell, at that rate, any suction fitting face plate,
return fitting faceplate, drain fitting faceplate, grate and
underwater light need to be removed. Hell, for that matter, you need
to drain the entire pool because the freezing water will blow out the
sides of the pool! You're wrong sweetheart. Face it. And I'll still
bet that you dont own an inground pool. Too bad for you.
Actually, if one thinks (like I did) and has the proper elevation
(like I do) one can cap all the pool lines, go to the pool pump and
pull the plugs. Out drains all the pool lines with no blowing,
flushing or adding of anti-freeze. Oh hell, I guess thats the wrong
way too and Im just luck.
Sorry but you're a din-wit
Bubba