View Single Post
  #3   Report Post  
Jeff
 
Posts: n/a
Default

The pressure switch is tripping at the appropriate times (or at least
consistent with the gage), it has settings for both cut in and cut out
pressure and I see the switch pop at the appropriate pressures. That said,
it is as if there is something else in the equation. I'm assuming the pump
is what pressurizes the tank... and even though the cut in is activated the
pump doesn't immediately activate. It seems the pump tries to cut on about
every minute. Most of the time, I see just an instaneous boost in pressure,
but every once in while it catches, I hear the water flowing and the
pressure tank pumps up to the cut off pressure (just over 70 psi). So I
have water periodically, as long as I don't use copious amounts at one time.

"Art" wrote in message
k.net...
Are you actually seeing the pressure switch trip at the right time? If

not
I would pull off the pressure switch and clean the pipe it connects to.
Gunk in the pipe may prevent the switch from feeling pressure drop even
though a guage next to it on another pipe sees the drop..



"Jeff" wrote in message
...
I have recently experienced well based water supply where the pressure in
my
pressure tank drops to zero and eventually repressurizes. The entire
assembly is just over two years old. It uses a submerisble pump (sorry,
no
make and model info) with a 20 gallon bladder pressure tank. The well

is
380' and had (at drilling) a 7 gpm flow, and we've been getting a fair

bit
of wet weather over the past 2 years, so I'm assuming that I haven't run
the
well dry. I've recently adjusted the cut in/cut out in order to get

some
additional pressure in the second story (though the adjustments weren't
too
significant, from 45-72psi to 50-74 psi). There is approx 38 psi above
the
bladder. This problem started approx. 2 weeks after making that change.

What I've seen from my trouble shooting. The pressure switch seems to

be
working correctly and there is power to the switch. While watching the
pressure gauge, I see a spike approx. once per minute as the ?pump?

tries
to
kick on. Eventually it catches (not sure if that's the right term), I

can
hear the water flowing and the pressure rises to the normal cut off and
the
pump cuts out. I can then run the water, decreasing the pressure in the
tank and watch the pressure swithc cut over at the cut in pressure...
though
the pump doesn't necessarily cut in.

Some other data points... from a zero pressure, I've seen the pump

catch,
and then cut off about a second after, but most of the time, it just

kicks
up the pressure (to approx. 40 psi) and then stops... this probably

takes
1/2 second.

Any help would be greatly appreciated.

Regards,

Jeff