It looks good but I found a flaw and the guy showing it at the show
acknowledged my thoughts. Like any router using a guide bushing the bushing
is probably not perfectly centered with the bit. YOU MUST keep the router
clocked in the same position as you run it down the straight edge or your
board will have a curved edge. Other than that I am considering one and
dumping my jointer.


"David Wittenberg" wrote in message
...
Hawk is offering a large (about 33%) discount on several
tools including their "JointAbility". Is this as good
as they say it is? At under $200, I'd consider getting
one.


--
--David Wittenberg