Allen Lung:
I'm looking for a 1/4 pattern cutting router bit, any ideas where I can find
one.


A "pattern" bit, or "template bits" have the bearing between
the cutter and the shank.

http://www.whitesiderouterbits.com/c.../TemplateT.pdf

In this case I don't think it's physically possible to have
a 1/4" pattern bit unless the shank were 1/8".

A "flush trim" bit has the bearing first, then the cutter
and then the shank.

http://www.whitesiderouterbits.com/c.../FlushTrim.pdf

In this case I'd claw around the CMT, Freud or Whiteside
sites and see what you can scare up.

http://www.cmtusa.com

http://freud-tools.com

http://www.whitesiderouterbits.com

UA100, who uses his pattern bit probably the most...