I have 220 volt extension cords all over the shop. Somebody more
attuned to the regs may tell you I'm crazy, I don't know. I just buy
the heavyest cable I can find, #12 extension cord or #10 stranded cable
with a heavy jacket off the spool. Put a plug on one end and an outlet
to match your tool on the other. Run the tool where you want to, not
close to where the outlet is.

bob g.

Ron Truitt wrote:
I am considering getting a 220 volt table saw but have 220 volt
available at the entrance to my garage and would have to have an
extension cord of 10 feet or so.

Is that a problem and if not are they comercially available? I have
never seen anything in 220 but am not use to the search.

Thanks,

RonT