Thank you Nahmie.
Much appreciated.

"Norman D. Crow" wrote in message
...



"Leon" wrote in message
om...
I am looking at getting the Makita 12 volt Impact Driver. Bought before
the
end of the year and Makita sends you an MForce cordless drill.

The unit is a 1/4" hex drive. With out a clutch how do you know if the
screw is getting too tight?

As the screw tightens up, it stops "spinning" it in, and it starts
"hammering" like an auto impact wrench, so you can see it slowing down and
ease off the power.

http://groups.google.com/groups?q=in...n&lr=&filter=0

Watch the wrap! This was a thread during Aug. '03. If you get the answer
"similar results omitted" tell it to give you all of them.

--
Nahmie
The law of intelligent tinkering: save all the parts.