We have Teknatool chucks at my club and to be honest I don't think
they compare with the Vicmarcs - the Vicmarcs just seem a hell of a
lot nicer.
Cheers
Paul


On Fri, 26 Nov 2004 16:40:37 GMT, Xlat
wrote:

My advice is to get a Teknatool product - products are nice, support
is good, very many different jaw sets available. At least that has
been my experience.
hth



On Fri, 26 Nov 2004 13:51:21 GMT, "Sanford Imhoff"
wrote:

Hello all. First time poster I own a Sorby lathe that I bought some years
ago when Farris Machinery was a US distributor. Due to a move the lathe had
been in storage for some years. Now that I have a shop I'm getting back into
turning. I currently use a Oneway chuck and have generally turned smaller
items...currently Christmas ornaments.

It has become annoying and time consuming to switch back and forth between
the one inch and two inch jaws and have decided to make another chuck
purchase to avoid the hassle. I've considered (a) another Oneway, body only,
which would allow me to use the jaws I already have (just the 1 and 2 inch);
(b) a cheaper Penn State scroll chuck that comes with a 1 and 2" jaw set,
or, (c) upgrade to a larger chuck and use the Oneway as my secondary chuck.

Anybody gone through the same thing or have any words of advice? Thanks in
advance for your help.



Remove the nospam from my address to email me!!



Unless otherwise stated all references to location refer to Western Australia