[original post is likely clipped to save bandwidth]
On 19 Nov 2004 07:48:09 -0800, (rud) wrote:

I am running a gas line out to my garage, however the run is about
120feet so I'll need to use a couple of rolls. I am using type L soft
copper tubing. Is it okay to solder joints in a gas supply line or
should I use flared fittings?

thanks

Check code!

Around my area (local codes):

1 - you must be a licensed gas fitter, skip that and your home fire
insurance goes up in smoke

2 - soldering/welding/brazing gas lines of any type is forbidden on
premises.

3 - all NEW natural gas and propane underground runs MUST now be plastic.

gerry

--

Personal home page - http://gogood.com

gerry misspelled in my email address to confuse robots