I need to fab 50-100 small (1"x1"), double sided, plated through hole
PCBs. No special requirements. Soldermask desireable but not essential.
Cost is of course the issue. What I've found so far is around $300 for
a full feature service including separating the boards. I've done this
before without soldermask and uncut for something like $100-150 and might
do that again but would rather not have to use the bandsaw and files.

Thanks.

--- sam | Sci.Electronics.Repair FAQ Mirror: http://repairfaq.ece.drexel.edu/
Repair | Main Table of Contents: http://repairfaq.ece.drexel.edu/REPAIR/
+Lasers | Sam's Laser FAQ: http://repairfaq.ece.drexel.edu/sam/lasersam.htm
| Mirror Sites: http://repairfaq.ece.drexel.edu/REPAIR/F_mirror.html

Note: These links are hopefully temporary until we can sort out the excessive
traffic on Repairfaq.org.

Important: Anything sent to the email address in the message header is ignored.
To contact me, please use the feedback form on the S.E.R FAQ Web sites.