One complaint about the RAS is that the table isn't quite level. I would
like a dado to be the same depth at each end, another reason to use a
router.
All tables can be adjusted so they are flat. Buy the Eakes book that shows
alignment for the Craftsman, Delta and DeWalt RAS's. Better yet, replace
the table with a 2 ply steel reinforced table like the Mr. Sawdust style
table. See
http://www.mrsawdust.com
--
Rumpty
Radial Arm Saw Forum:
http://forums.delphiforums.com/woodbutcher/start
- - - - - - - - - - - - - - - - - - - - -
"Steven and Gail Peterson" wrote in message
ink.net...
I have a Vermont American dado blade set that I use in my Craftsman RAS;
it
will try to self-propel if you don't keep control, but it isn't too hard
to
control, at least on things like plywood. A hardwood, like oak, might be
more trouble, but I usually use a router on such.
One complaint about the RAS is that the table isn't quite level. I would
like a dado to be the same depth at each end, another reason to use a
router.
Steve
"Rumpty" wrote in message
...
IME, crosscutting dados with my Craftsman RAS is a bit tough because
the
blades really grab the wood and the carriage lurches forward. While
there
are RAS blades made to help avoid this when simply cutting, I do not
know
of a dado blade designed for the RAS.
Forrest make a great dado blade that works well on the RAS.
carriage lurches forward
The roller head bearings might be too loose and require adjustment. You
need
to hold onto the motor with some positive control.
--
Rumpty
Radial Arm Saw Forum: http://forums.delphiforums.com/woodbutcher/start
- - - - - - - - - - - - - - - - - - - - -
"igor" wrote in message
...
On 17 Nov 2004 20:01:02 -0800, (Keith) wrote:
I am considering buying a Craftsman RAS for mostly dado work. Does
anyone have any info thay can share about there experiences with the
Craftsman?
IME, crosscutting dados with my Craftsman RAS is a bit tough because
the
blades really grab the wood and the carriage lurches forward. While
there
are RAS blades made to help avoid this when simply cutting, I do not
know
of a dado blade designed for the RAS.
This you may know, as it applies to RAS in general: If the wood does
not
sit flat on the TS when you cut a dado, the dado will be too shallow --
and
you can cut it again in the same piece of wood. Of course on the RAS
if
the wood is not flat the dado is cut too deep. For example, if you are
ripping a dado on a long piece with the RAS and the wood is not
supported
well, it can arch upwards along the way and you cut too deep. For that
matter, even crosscutting in a long piece can cause problems, but they
are
a bit easier to catch before you cut. So, you have to be plan
accordingly
to ensure that the wood is flat to the table.
All that being said, it can be much easier to cross-cut a bunch of
dados
in
8' long pieces using an RAS than a TS. HTH. -- Igor