On Thu, 04 Nov 2004 12:29:09 +0000, Kalico wrote:
On Wed, 03 Nov 2004 09:40:01 GMT, "R Taylor"
wrote:
Frank Stacey wrote:
For various reasons I find that a plumbing job on which I have embarked
involves using plastic (HEP) pipe for various awkward runs with copper at
either end. Am I right to assume this can be done without restriction?
In some places I am using straight metal compression couplers between copper
and plastic with an insert in the plastic pipe. In other places I have
plastic elbows with plastic on one branch and copper or chrome plated copper
on the other. Are there any gotchas I should know about?
Excuse the paranoia, but once completed most of this stuff is going to be
under the floor of a small bathroom and very inaccessible. I dread having
to rip out my carefully installed fittings as water seeps through the
ceiling below!!
Frank [the tentative plumber]
you can mix copper and plastic tube, no probs. fwiw, I wouldnt waste time
with potentialy problematic compression fittings, I'd use speedfit throughout.
fit and forget.
RT
Speedfit! No way - use Hep2O instead and worry less about leaks.
I've never had problems with any of the major brands, including
Speedfit.
--
..andy
To email, substitute .nospam with .gl
|