Charlie wrote:

Just wondering if anyone can help me, I've got a phillips IC based amplifier
circuit and I need to power 100v line speakers, am I right in thinking that
as long as I match the Impedance (4-8 Ohms) and chuck a couple of diodes in
I can use a 100v line transformer on the amplifiers outputs? any help is
greatly appreciated!

You forgetting what the circuit is actually doing. A distributed
commercial sound high Z amplifier puts out 70 or 100 volts at its full
output. Note this is VOLTs and not WATTS. So, a 1 watt amplifier could
have a 100 volt output as well as a 100 watt amplifier. Both have output
transformers. What's the difference? The turns ratio and wattage
capability. A 1 watt amp would have a higher step up turns ratio to make
its output swing compared to a 100 watt amplifier. SO to answer your
question, you cannot just use any old 8 ohm to 100 volt transformer and
expect it to work properly. The transformers wattage must match or be
close to what your amplifiers is. And hopefully the step up turns ratio
will be about the same if you do.

Also, some output stages don't like the reactive load of a output
transformer.

Bob


----== Posted via Newsfeeds.Com - Unlimited-Uncensored-Secure Usenet News==----
http://www.newsfeeds.com The #1 Newsgroup Service in the World! 100,000 Newsgroups
---= East/West-Coast Server Farms - Total Privacy via Encryption =---