Ouch.

Actually, after all the "professional" feedback, this woodworker will
NOT drop money for the lift. Even if the feedback had been "it's great
you've got to get it" it would probably not have happened -- it's so
low down on the priority lists.

The real question is what kind of woodworker, I'll refrain from the
derogatory term "worddorker", would by a $250,000 router? That seems
high even for a factory floor. Is it for mouldings? Surely it does
more than route.

BTW, I am tired of reaching under my table and repeatedly adjusting
measuring, adjusting-measuring, etc. until I creep in on an accurate
enough setting......

Also question to the whole group, not just UA100: given all the
anti-router lift pro-shaper feedback, I'd say none of you uses a
router lift. I find that difficult to beleive. Surely there's someone
out there willing to 'fess up.


Unisaw A100 wrote in message . ..
Never Enough Money wrote:
http://www.jointech.com/
Looks like an advancment to me. Of course it cost almost $500.00,
that's just for the lift, no router included.


Looks like someone(s) lacking basic wooddorking skills will
soon be out five hunnert dollars.

UA100, who to be truthful, has relied on a $250,000 router
(at work of course) from time to time...