Before you resand the area, try covering it with cotton cloth and using a
hot iron or
heat gun. This will SOMETIMES pull the moisture out. It usually works to get
moisture
rings off tables. Just be careful not to melt the finish.
Dave in Cherrylog, Ga.

"Owen Lowe" wrote in message
news
In article _pDdd.506023$8_6.90105@attbi_s04,
"Ralph J. Ramirez" wrote:


I am interested in finding out what the limits of humidity should be when
spraying lacquer on my turnings. I use an HVLP sprayer and spray
outdoors
in a 2 sided enclosed canopy but use a spray can for bowl repairs. I
have
been spraying for several years without any problems. That said, here is
a
problem I came up with yesterday. I was in the process of making some
very
minor repairs to some bowls that had been damaged by people handling them
during an open studios tour. It had rained the day before and early the
morning of my problem. I sanded the damaged area of a bowl then
proceeded
to spray it using a spray can of lacquer. As it started to dry I could
see
a haze building up, needless to say I now had to repair the repair. I
will
now have to remove the haze by sanding then re-spray the bowl, whenever
it
is safe to do so. I have used this process to make minor repairs many
times
before without problems, however; never directly or shortly after
rainfall
(rain started early here in my area). I am sure it is a humidity problem
but I am not sure of the solution/prevention for the remainder of the
winter
season. My question; at what humidity levels is it safe to spray to
avoid
this problem of hazing? Today, the humidity level is at 50% inside my
shop

Hi Ralph. Yes I believe your problems are moisture caused. Check out
Russ Fairfield's lacquer article on WoodCentral:
http://www.woodcentral.com/russ/finish11.shtml
The rest of the series is quite helpful too so is worth a bookmark:
http://www.woodcentral.com/russ/russindex.shtml

--
"To know the world intimately is the beginning of caring."
-- Ann Hayman Zwinger