"raden" wrote in message
...
In message , Rory
writes
raden wrote:

That's not what I was on about

Sorry. What were you on about?

DIMM was talking about running his pump from his programmer

Maxie,are you asking DIm Lin the far eastern luscious lovely about this? My
oh my....

I understand about pulsing the pump every 24hrs and on initial power
up, the question that's bugging me (which you may know the answer to)
is;
When the boiler is going through it's relighting procedure after
pausing having satisfied the boiler stat (but not the CH or HW stat)
does the controller deliberately momentarily disconnect the pump?

Yes,


If, perhaps, the controller shouldn't do this, or the firmware has been
upgraded, then it would be worth me changing the PCB to cure the
annoyance this causes.

They all do the same, your £150+ would be wasted.



The information contained in this post
may not be published in, or used by
http://www.diyprojects.info


--
geoff