Thread
:
Routing a 3/4" Chamfer in a 1 1/2" stock
View Single Post
#
6
mac davis
Posts: n/a
On 17 Oct 2004 16:32:54 -0700,
(Jerry Korea)
wrote:
This may sound like an easy question but ... I need to cut a 3/4"
chamfer in a circle cut from 1 1/2" stock. I have a 45 degree bit but
it does not seem to cut a large enough chamfer -- what is the best bit
for this job. Thanks in advance and sorry for such an easy question
Jerry
If you have a disk sander with a tilting table, I'd use it and a home
made circle sanding jig..
I use 1/2" shank router bits in a drill press and I don't think I'd
try that heavy a cut on it..
Reply With Quote