I paid $900 for a 1994 3 HP right tilt Unisaw but got an outfeed
table, a box of blades (including 1 Forrest Woodworker II slightly
used and a Freud dado set), and a side table as part of the bargain.
It's the 240 volt version. I have no idea whether I got a good deal or
not - I figure worrying about it at this point would be useless.

I haven't heard of a 1.5 HP Unisaw so I'm guessing it was prior to
1994.

BTW, you can call Delta and they will tell you everything baed on the
serial number.


(Mule) wrote in message . com...
Just got back from the auction. Not many people there, so that meant
great savings. Here are the facts I have already:

Plate on the saw says it is a 34-450. Serial # is ep7248. I don't
know if that helps with identification, but thats what it is. The
plate on the motor says it is a 115/230, 1 1/2 HP motor. The model of
the motor is 83-621. Again, not sure if that will help.

Looks to be a solid saw. Bearings are fine. There was no fence, but
from what I have read in back posts, that may be a good thing. Its
got a little surface rust on the top , but otherwise was in good
condition.

Anyone who can help me narrow down years it was produced, and info on
what was good/bad about those specific saws will be openly praised.
Also, what were the most common alterations to it besides the fence
swap? A guess as to how much it would go for?? I'll wait for a
response or 2 before posting actual retail price....

Thanks again!!