From another point of view, he's looking to face plane, not edge joint. In
those cases, say with a 6'x10" board, it's rare that you really need a board
that's flat along the entire length of its face. And, if it were so, it
probably wouldn't stay that way for very long. Other than for a workbench
slab, that is.

As it'll typically be locked down to a frame or other supports, you do need it
flat across the width, and flat for a short distance along the length of the
face. Your thickness planer suggestion meets those requirements. I've done
that with quantities of rough lumber.
GerryG

On Wed, 29 Sep 2004 07:40:51 -0400, "George" george@least wrote:

Reason is simple. You really don't _need_ as wide a jointer as you think you
do. Knocking the high spots off / shimming the low spots up prior to
planing a wide board, or fully supporting it on a planer sled will handle
even the worst case scenario. Most boards plane adequately by taking light
cuts and alternating properly.

The piddling European machines Andy mentions have jointer tables which,
according to the rec "wisdom" are too short for proper use.

"Eric Anderson" wrote in message
. com...
One conflict that still exists that I have not seen a good solution
for is a jointer that matches the width requirements that an average
woodworker has.