Grant Erwin wrote:

How'd you mill a pocket with square corners? - GWE

steamer wrote:

--Getcher self a hunk of steel bigger than the end of the ram and
mill a pocket in it. Drill and tap the center for a long setscrew and use
this to attach tooling. Tap two sides of the box for thumbscrews to hold
it on the end of the ram. I tried selling a product that did this and the
response was underwhelming to say the least. But it works... ;-)


You drill a hole at each corner and mill the sides of the pocket with a
mill of smaller diameter than the drill you used.

Cheers
Trevor Jones