I need to cut some pieces out of a plastic bath panel. It is for a corner
bath, so curved in two planes, about 5mm thick. Attempts with a hacksaw
have so far proven the panel to be extremely brittle & prone to crack. I
don't have much hope that a jigsaw will be any better. Any ideas or
experience to share?

Thanks for your replies.

Paul Shortman.


On a related note, there is a small crack in the top of our plastic bath
panel (only a few mm at the moment so you cant normally see it as it is
tucked up behind the rim of the bath) - is there anything I can put on the
back to stop/slow the crack spreading?

cheers

Dave.