On Sat, 25 Sep 2004 11:10:59 GMT, "Bob"
wrote:

I want to drill several 3/4" holes for bench dogs in a laminated workbench
top (prior to assembly) that will be 3 inches thick. My preferred approach
would be my drill press with a 3/4" Forstner bit. The bits I have will
barely hand 2 1/2" depth. I need suggestions for the deeper hole. Right
now, I'm looking at buying a good old fashioned Brace and bit. I'm sure
some will suggest drilling part way, than flipping over and drilling from
the other side. I don't feel that's a very precise operation, but if you
have a technique to do it, I am all ears.

Bob



A drill guide with your corded hand drill and a spade bit. Clamp the
drill guide to the bench. Every inch or so, clean out the hole with a
shop vac hose. A new spade bit is inexpensive and sharp.