I would suggest a dry run, try clamping the assembly with no glue; the edges
should close perfectly. If they don't, plane them until they do. It is
best if the edges meet first at the ends of the boards so that the clamps
can bring the middles together.
Good luck!
"Corey" wrote in message
news:sVg5d.3107$Cn.3014@trnddc04...
Well, I think I'm ready to glue sets of 3 3.5" boards for my intro project
to make the sides, top, bottom, and shelf. I think I understand the
basics - apply a healthy amount of glue to each adjoining edge (enough
glue
to where just a bit squeezes out when clamped), clamp about every foot of
so, and let dry per mfg specs (preferably overnight, if possible).

Any advice of tips on gluing the butt edges (I've decided to follow the
majority of the advice here and pass on the dowels, by the way)?

Thanks