"JGS" wrote in message ...
Hi Greg,
Thanks for the post. I picked up a few ideas that I will use when I
rebuild my
current set up. A question, how did you get the saw to be at the same
level as
the L/R tables?

The tables were built to match the height of the SCMS bed. I knew I couldn't
get it "exact" so I used an old trick - I mounted the SCMS on small rubber
feet and used screws with rubber washers to bolt it down. That way I can
tighten or loosen the screws to get a slight raise or lower of the bed.

you could get the same effect by sitting the saw on some hard(ish) rubber
blocks.

I currently use playing cards to shim mine but there must be a
better way. Is the saw bolted to the sub table? Cheers, JG

Glad you got some value from it.

cheers,

Greg