"Charles A. Sherwood" wrote in message
...
turned out to be rubish made in India I then bought a Vertex.
Unfortunately it has not turned out much better. Center hole is not
on center of table and there is play in the rotation that make this RT
unsuitable for close tolerance work. If +,- .003 were okay it would
be fine, but I am hoping to do a little better.


I want a 6 inch RT for my rockwell mill. I was under the impression that
the vertex is better that the phase II, but now I wonder. Both are
about 200. So which is better?


Buy them both...let us know....

xman