On 29 Aug 2004 07:49:47 -0700, (Harry K)
wrote:

"Nate B" wrote in message ...
Hi,

Roof is covering small 11x13 outbuilding. Slope is 4:12. Using 2x8 ridge
board and 2x6 rafters.

No problems with the rafter trig - got that covered. No problem with the
span of the 2x6 rafters either. A mere 11 ft / 2 = 5.5 feet (roughly) - all
to code. Overkill, but I want an R-19 roof.

My question is this: I've looked at a bunch of codes, and I can't seem to
find anything that covers the span of the *ridgeboard*, especially as it
applies to the roof slope. I'm certain the ridgeboard can not span as far
on a 4:12 as it could on a 6:12, for example.

I'm probably overkill like the rest of the roof, but I'd like to know for
100% certain. Snow and 100 mph wind load codes apply at this location.

I know a steeper roof would be more bomber, but I want to match the house.

Any references?



Thanks,

- Nate

I don't think there is a code for it. The 'span' in a properly built
roof is only from one rafter to the next. Collar ties (or joists)
keep the walls from spreading and the rafters support the ridge board.

Harry K

I'm not a structural engineer, but...

What Harry says is true unless the OP is planning a structural ridge,
meaning no joists or collar ties. In that case, I believe the ridge
supports one-half the total load of the roof, and the walls support
the other half. Posts under the ends of the ridge carry the load to
the foundation.

A steep pitch increases the total weight of the roof system (because
of longer rafters and more sheathing). The snow load stays the same,
so the ridge carries more load (in the case of a structural ridge).

HTH,

Paul