I have a bench on my site that may give you some ideas, the design is very
flexible and may suit what you want. I use it to store wood, as the wood
uses an incredible amount of space when just stacked around the shop.

http://woodworking.homeip.net/wood/w...ench\index.htm

and some more at:
http://woodworking.homeip.net/wood/bench\index.htm

vise is shown at:
http://woodworking.homeip.net/wood/Vise\index.htm

--
Greg
http://rec.woodworking.homeip.net/wood/

"Brikp" wrote in message ...
In my limited experience I have never seen or heard of this being done. I
want to know if I am nutz, misguided, mis-informed, ignorant or brilliant!

My Griz 1023s table saw and mobile base is on its way. I need a general
purpose workbench as well. I was thinking that once I had my TS in place
where I would use it most of the time that I would build my workbench at
the
same height and butt up against the table saw table. I figure I could use
this as an outfeed table when needed and as a general purpose bench at
other
times. I was also thinking of incorporating a router and some t-tracks.
Storage and compressor underneath.

Good or bad idea?

TIA