I want to remove a couple of radiators to decorate - I have done it many
times and the (Twinfast) valve always leaks a little - but I put a tray
under to collect the drips. However, this time we are getting a new,
light
carpet! I want to blank off the valve outlet where the radiator attaches
to
reduce the risks until I am ready to re-fit the rad.
Question - what do I need to blank off the valve? What do I ask for?
A screw on blanking plug for a radiator valve. If you just explain what
you
need in plain language to any plumbing supplier they'll give you the right
bit.
--
Dave Baker - Puma Race Engines (www.pumaracing.co.uk)
I took one off this morning - just needed a 3/4" cap, about £1.20 from the
builders merchant up the road (needed a few turns of PTFE on the valve
thread too to make it watertight under pressure).
On a related note, can you run a combi boiler for just DHW with the CH
circuit depressurised/drained? I wasnt sure which is why I blanked the valve
and refilled the system, obviously dont actually need CH at the moment but
hot water is a must.