In message , Jerry Built
writes
Tom wrote:
It's a Randall 4033. Can any kind soul tell me how to get into
it without destroying it?

I seem to remember that if you undo the screw that holds the
cable connector in (look upwards underneath the thing) that
when the cables are disconnected you can slide the whole outer
cover up and off, leaving the back screwed to the wall. Maybe.
Look up it with a torch and see.

No

Randall 4033 -

remove the two nuts on the switches and remove the cover, you might need
to move the tappets around to get it past the dial

There are two screws at the top which you need to unscrew to release it
from the backplate. Lift the timer body upwards to remove it from the
backplate.

To remove the back of the timer, you need to remove the three push-ons
which retain it, (best done with an electrical screwdriver on one of the
teeth , moving around until it's loose )

You are now inside the Randall 4033.

What do you want to do now ?

I've just thrown 20 - 30 out this week in a big clean up, but still have
lots of bits around

ring me if you need some bits - details at www.cetltd.com
--
geoff