wash tank with hot soapy water, then fill tank with water 95%, position tank
so air pocket in the weld area, and weld your area.


Tony
"wallster" wrote in message
...
I have an old gas tank off of a motorcycle that needs a mounting tab
tacked
on to it. When I emptied the tank, the gas was real old and smelled like
varnish so i flushed the tank with acetone (rusty in there), then rinsed
it
out with soapy water several times. I dont think it would explode because
of
the age of the fuel that was in it and it was thoroughly rinsed but i'm
not
a big fan of blowing my fingers off my body so i'm a bit relunctant to mig
this thing. A friend suggested to go outside with the cap off and stick a
propane torch in the opening and see if it flashes. If it doesn't, it most
likely wont explode. Any comments before I muster up enough nerve to tack
this tank.

thanks in advance,
walt