"Randy H." wrote in message
news:jaeTc.41087$Oi.32787@fed1read04...
I did the same thing. I got a hole in my tank from something that got
kicked
up off the road. I filled the tank with water and as much as I could
leaving
only a small air pocket. I was going to braze weld it shut with my propane
&
oxy torches. I had at least 90 % full of water. When I put the torch to it
the tank still had enough vapor in it to cause it to give a big burp.
Water
sprayed me all over from the fill hose. It scared the snot out of me! I
wasn't sure if it was the water from the tank, or if I ****ed my pants!

Randy Hansen
SC Glass Tech
Scam Diego, Comi-fornia


hehehehe.... where's a camera when ya need one!
walt



"Randy Zimmerman" wrote in message
news:xOdTc.96746$M95.53638@pd7tw1no...
Just fill the tank up with water. Close the cap and vent tube. Turn
the
tank over so that the area that you are going to weld is located at the
small air space left in the tank.
I have done this with Oxy-acetylene and occasionally I would get a
little burp at the crack or opening I was repairing. There wasn't
enough
space for any gas residue to have any power.
Randy

"wallster" wrote in message
...
I have an old gas tank off of a motorcycle that needs a mounting tab
tacked
on to it. When I emptied the tank, the gas was real old and smelled
like
varnish so i flushed the tank with acetone (rusty in there), then
rinsed
it
out with soapy water several times. I dont think it would explode
because
of
the age of the fuel that was in it and it was thoroughly rinsed but
i'm
not
a big fan of blowing my fingers off my body so i'm a bit relunctant to
mig
this thing. A friend suggested to go outside with the cap off and
stick
a
propane torch in the opening and see if it flashes. If it doesn't, it
most
likely wont explode. Any comments before I muster up enough nerve to
tack
this tank.

thanks in advance,
walt