Jay Pique wrote:
snip
Took it all back apart and started
the fettling process. I used ScarySharp (the use of abrasive paper in
lieu of sharpenijng stones) and lapped the sold of the plane flat up
to 600 grit (I think - I've since gone to 1200). Then I put a slight
chamfer on the leading edge of the mouth and the back edge of the sole
to avoid catching.

I'm glad that you're enjoying the seduction of handtools. %-)
Next time around, reassemble the plane, back the blade up so it
doesn't take a cut and then flatten the sole. Unless it's
flattened while stressed, it won't be the same shape as when it's
being used. The leading edge of the throat is the important part
of the throat. It needs to be flat and sharp to work properly.
If you've chamfered it the way I envision it, you're allowing the
wood too much room between it and the blade. I's possible,
though, that I've just misunderstood you. I'm glad that it works
for you. Now collect a handful of old Stanleys and make them work
right.
Dave in Fairfax
--
Dave Leader
reply-to doesn't work
use:
daveldr at att dot net
American Association of Woodturners
http://www.woodturner.org
Capital Area Woodturners
http://www.capwoodturners.org/