BTW be careful, the convergence system on this set is NOT user friendly.
Take note of where the values are so if it gets worse you can put it back.


--
Jammy Harbin
J & J Electronics, Inc.
227 S. 4th St.
Selmer, TN 38375
731-645-3311
"James Sweet" wrote in message
...
Finally think I got this thing going, remote problem was a bad micro, now
that it's had both the convergence and vertical deflection chips replaced,
power supply work, etc it's in need of some tweaking. Seems to be very few
adjustments on the convergence board, I assume there's a service menu? How
do I get into it?