Look for a hole in the plastic of the control panel, almost dead center.
Hidden microswitch behind that sets factory mode. Press the button once to
enter, and when done press to exit. A paperclip makes a good button pusher!


--
Jammy Harbin
J & J Electronics, Inc.
227 S. 4th St.
Selmer, TN 38375
731-645-3311
"James Sweet" wrote in message
...
Finally think I got this thing going, remote problem was a bad micro, now
that it's had both the convergence and vertical deflection chips replaced,
power supply work, etc it's in need of some tweaking. Seems to be very few
adjustments on the convergence board, I assume there's a service menu? How
do I get into it?