View Single Post
  #3   Report Post  
Archie
 
Posts: n/a
Default Washer/Dryer doesn't dry


| Hi, I have the Indesit Omega 1200 (WDG1295W) Washer/Dryer.
|
| When I have a relatively small load of socks etc. and put them
on to dry for
| 120 mins. following a thorough spin-dry, they do not dry
properly. It takes
| a total of 6 x 120 min. sessions (12 hours!) before they are
reasonably dry.
|
| This is a washer/dryer with no air exhaust port, it just says
in the manual
| that it uses the water expulsion pipe to get rid of the air
(presumably this
| just comes out of your sink hole). It has always been bad, but
seems worse
| lately.
|
| Any ideas?
|
| Thanks in advance.
|
| Andy
|

Andy, I don't know this machine. However:

1. Does it feel warm at all inside? - heater working? How about
the fan (can you hear it)? - check your house electric meter
after switching on the dryer/heater - the meter should go round
showing electricity usage!

2. Does the wash cycle pump water out OK? Then, check that are
all pipes/tubes clear from beginning to end (including condenser
to machine drain pipe).

3. Is inside condenser clear too? if you can check it of course

NOTE: Please do NOT leave machine on the Dry cycle for so long!!

Cheers
Archie