MDF is OK, but the dust and mess, and it is abrasive, so hard on tools.

In addition, the surface is harder than the centre, so if you are laminating
layers, you will end up with hard and soft sections, like grain lines in
soft timbers, which can make finishing more difficult than it need be.

That said, the stuff can be turned and easily as there is no grain.

We had a competition down here a few years back where one category as for
"engineered wood". Follow this link to have a look at what you can do with
it.

http://www.sawg.org.nz/Galleries/mem...ome%20page.htm
then go to Terrys gallery, and look at piece Number 8




Rex
Auckland
New Zealand
"Francis R. Vesey" wrote in message
...
I am making a prototype part for work that is basically a 18" bowl with a
raised center. I was wondering if MDF would be a good candidate for this
project. Any thoughts would be appreciated.


---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.726 / Virus Database: 481 - Release Date: 7/22/2004