"Arri London" wrote in message
...
"Dave, Chris & Ben Oinonen Ehren" wrote:

in article , Arri London at
wrote
on 1/6/04 7:05 PM:

lbbs wrote:

I imagine putting some find of a filter at the end of the vent house
would
do the trick, and direct the vent into the laundry room. Some one
mentioned that the added humidity in the room might actually make the
drying
process take longer (it need dry air). Although in my case might
not be a
problem because the room is very large (24x24). Anyone ever tried
this,
did it work good, any problems? Thanks


My (electric) dryer was in my kitchen and in winter I never opened the
window to let it vent. The filter was very fine-meshed and there was
no
dust or lint on any surfaces. The washing was always run through a
separate spinner, so it wasn't all that wet. The extra humidity wasn't
really a problem; only the window ever showed any condensation and
that
disappeared in a few minutes after the dryer finished.

In climates where the winter is cold and dry (like MN & WI) having the
extra
humidity and heat inside is a boon, but you want to be able to switch it
back to venting outside in summer, 'cause then the heat and humidity are
a
drag. Also want to monitor the humidity-get a humidistat. They're
pretty
cheap. You don't want the humidity to get over 50% if you can help it.
That can do damage to your house, as well as encouraging dust mites and
mold.

That wasn't really a problem in London. Outside humidity can easily be
50 percent or more on a regular basis. As for dust mites and moulds,
keeping the house clean really does minimise those problems.
LOL not to mention my flat was in a 260+-year old church. Any wood was
buried within metre-thick walls of stone and later concrete. The floors
were also concrete about 2 foot thick. Mould was never an issue.

How do they run plumbing and wiring and ductwork in such a structure?




I've seen indoor dryer vent attachments in Home Trends (a catalog). I
think
they have a website.

Chris OE

--