Thread: Shed doors
View Single Post
  #6   Report Post  
Posted to rec.woodworking
ScottWW[_2_] ScottWW[_2_] is offline
external usenet poster
 
Posts: 3
Default Shed doors

"knuttle" wrote in message ...

I have a 10 year old shed for my lawn tools, that is 2X constructions, with
standard particle board siding. While the outside was painted immediately,
the inside of the siding was left unpainted. The doors are basically a
sheet of siding with 2x4 around the edge of each door and in an X pattern
in the bottom half of the doors . The doors overlap the floor joist and
come to the bottom of the floor joist. The minimum clearance under the
shed is about 8" and is open on all four sides.

That area between the door and the joist has started to come a part Since
at this time the decomposition is minor, can i stave off the replacement of
the door by gluing the loose particles and painting that are of the door?


Is there a better solution?


Treat with bleach/antifungal. Stabilize with a wood hardener and reinforce
with filler.
I don't know if particle board/OSB is susceptible to dry rot, but it does
travel thru painted wood once it has begun.

Protect and paint the bottom edge of the particle board face well as this is
where the water runs down to, and pauses before dripping.
When replacing in the future, don't use particle board or OSB, even if it is
intended for outdoor sheathing. (it is meant to be enclosed by other
membranes.)
While it is not in direct contact with the ground, it is ground-adjacent.
I'd consider prefinished cement/concrete board, buit at least use PT.

my 2ยข
Scott