On 5/12/2021 9:20 PM, Casper wrote:
This morning I was able to remove 3 of the 4 brass thread nuts. The
last was stubborn. After further freezing, I got the 4th off. Only
things I used were WD40, Ballistol, and freezing.
The wheels are not pop-in, they have threaded steel shafts.
https://www.dropbox.com/s/iku0193rzc...%20PM.jpg?dl=0
Might try letting a temp change loosen the nuts.
I "HAD" a Kreg miter gauge years ago. It used a brass bin to index into
aluminum.
A couple of hours with direct sunlight and the pin seized. And of
course I forced the pin out with all means possible and the miter gauge
was no longer and good to me.
I replaced it with an Incra miter gauge. Steel on steel. ;~)