On 4/8/2021 8:34 PM, Clare Snyder wrote:
On Thu, 8 Apr 2021 19:01:00 +0000, Buddy
wrote:

Ive had my ms290 for 14 years no problem and this just started. Pulls easy with plug out but you have to fight to pull it. with plug in. Was able to start it then could not restart.
Now it wont start at all but still pulled and jerks very hard.
Pulled muffler off..ok..pulled flywheel off..ok..and by the way it does not have a compression release.
I realize you have to tug on these saws but this is something that still has me scratching my head? Any ideas would be great. I want to save this saw.
Carbon build-up?


I was going to say that ... chances are this is a homemoaner who uses
the saw to trim a couple of branches a couple of times a year . And it's
never been run wide open since the day it was new , and "if one ounce of
oil is good 2 must be better" . I'd bet that piston has enough carbon
buildup to jack the compression ratio pretty high .
--
Snag
In 1775, the British demanded we give them our guns.
We shot them.