On 2/18/2021 11:24 AM, Scott Lurndal wrote:
Leon lcb11211@swbelldotnet writes:
On 2/16/2021 6:18 PM, Bob D wrote:
Has anyone used a Wixey laser cross hair adaptor for a drill press? I can buy one at Rockler for $37.50 or buy a new powermatic drill press for $1500 or do nothing.

Bob



My Delta DP came with one. Unless they have gotten a lot better, I
would not advise getting one.

I never ever used it. I felt that a laser on a DP would be as useful as
using one on a sander, or hammer. ;~)

You do have to actually drill a hole at some point, let the bit be your
pointer.

If you need to pin point a location before hand, use a 1/16" bit to line
things up.

Or use a brad-point bit.



That too, but a smaller one. If drilling at an angle the spurs on a
larger brad point bit can prevent the point from touching the exact
spot, for initial alignment.

I had that issue when using drilling these holes for wine bottle stoppers.

https://www.flickr.com/photos/lcb112...7630857421932/