On 17/02/2021 20:15, williamwright wrote:
On 17/02/2021 15:35, Jimmy Stewart ... wrote:
Just got my first keyless chuck drill and I am having
problems......bought a new bosch 550 wired drill to replace my old
black and decker and Stanley drills and a 20mm masonry drill to open
up the holes in a teracotta airbrick.....anyway got the bit tightened
and started drilling on the hammer settings and after a few seconds
the drill fell out and rolled down the roof to the ground......this
can't be normal... am I doing something wrong?....instructions just
say tighten until clicks are heard......doesn't matter how tight I
make it the drill still falls out....any ideas ? ...

Bosch say it's only for masonry drills upto 10mm. It's actually a
pathetic little toy. Not even SDS! You need to spend a lot more.

Bill
I'm cheap ...