Angle of washing-machine inlet hose?
y65;6200;1cOn 2020-12-17, Tim Lamb wrote:
In message l.net,
Dave Liquorice writes
On Wed, 16 Dec 2020 13:27:21 +0000, Adam Funk wrote:
Maybe the angle make the hose less likely to become strained while
you're shoving the appliance into the slot?
That's about all I can come up with as well. Assuming that the supply
end of the hose has a straight connector and that the supply pipe
also has a straight connector meaning the joint is parallel with the
wall.
I think, as has been hinted, it is to encourage the pipe to form a
circular loop which can be safely pushed close to the wall.
That makes sense.
Next question --- why is the drain hose, which is permanently
attached to the machine (unless you open it up) made of such flimsy
material?
|