DIYbanter - View Single Post

[email protected]

On 30/11/2020 15:38, Robin wrote:
On 30/11/2020 15:05, wrote:
On 30/11/2020 14:44, Andrew wrote:
Has anyone done this ?.

I have a 22mm bending spring intended for 22mm copper
and it is a fairly loose fit.

I was going to heat the pipe with my hot air gun
and bend it around something round or maybe
hammer some nails into a bit of old plywood and
use them as a 90 degree guide.

I am replacing the gas pipe that was used to run
power from house to garage in 1976 with the correct
stuff, so needs a 90 degree bend at each end to fit
a metre wide path, before re-instating the path
(dug up for other reasons).

Andrew
Why aren't you using SWA cable?

ahem, I guess 'cos he is "replacing the gas pipe

ahem ahem, and what's inside the "gas" pipe? ;-)