On 30/11/2020 14:44, Andrew wrote:
Has anyone done this ?.

I have a 22mm bending spring intended for 22mm copper
and it is a fairly loose fit.

I was going to heat the pipe with my hot air gun
and bend it around something round or maybe
hammer some nails into a bit of old plywood and
use them as a 90 degree guide.

I am replacing the gas pipe that was used to run
power from house to garage in 1976 with the correct
stuff, so needs a 90 degree bend at each end to fit
a metre wide path, before re-instating the path
(dug up for other reasons).



another vote from me for swept bends


--
Robin
reply-to address is (intended to be) valid