View Single Post
  #24   Report Post  
Posted to sci.electronics.repair
[email protected] ohg...@gmail.com is offline
external usenet poster
 
Posts: 96
Default can't figure correct resistance for teflon coated copper wire

On Friday, November 13, 2020 at 3:41:19 PM UTC-5, Runner wrote:
On 11/13/20 3:07 PM, Fox's Mercantile wrote:
On 11/13/20 12:57 PM, legg wrote:
I don't recommend electric blankets. For a multitude
of reasons.


I just bought a new one.
I turn it one 20-30 minutes before I go to bed.
I turn it off when I go to bed.
But when I go to bed, the bed is nice and warm.
Beats the **** out of laying there swearing for 15-20
minutes waiting for the bed to finally get warm.


If a Sunbeam, good luck keeping it working. I went through three in
five years before finally going the DIY route. I'm not sure what's
happened to them. I couldn't even get any of the ones I bought to last
out the season. I think it has something to do with the current circuit
they use and the blanket wiring. Growing up, my parents and I had their
blankets and they lasted 15 years before I unfortunately tossed them a
decade ago.


Sunbeam blankets don't flat out quit, they slowly get colder over time. Not sure why that is. It's like they're programmed to do so. Too bad because their controllers are great. I switched to their mattress pads and they get inert over two or three seasons. Looking for another option right now.