On 07/10/2020 16:11, newshound wrote:
On 07/10/2020 16:01, Jimk wrote:
Any top tips to avoid draining down a hw cylinder in order to
Â* change a tap washer?
something that I can bung in/over the seat & reduce losses whilst
Â* I fart with the jumper?
Or ought else?
TIA
Depending on the design, there is often a gate valve somewhere near tehe
tank (or possibly from cold cylinder to tank) that you can turn off
(recognisable by round pressed-steel handle). Or you can sometimes put a
rubber bung in the bottom of the cold tank, in the pipe that feeds the
hot cylinder.
+1
and another bung in the vent pipe will save needing to drain the content
of the feed pipe though the cylinder as well.
--
Cheers,
John.
/================================================== ===============\
| Internode Ltd -
http://www.internode.co.uk |
|-----------------------------------------------------------------|
| John Rumm - john(at)internode(dot)co(dot)uk |
\================================================= ================/