On 14/08/2020 12:22, williamwright wrote:
On 13/08/2020 20:17, Dave Liquorice wrote:
The OP says he changed drilling machine but not if he used and
kanckered an 6 mm SDS bit or used the same Bosch drill in an ordinary
chuck fitted to the SDS machine. Not that you are suposed to use SDS
in hammer mode with such a chuck fitted.
The mass of the chuck inhibits the percussive action. The bit slips. It
just doesn't work.
Not sure if mass alone would account for it. For example I have some 1m
long SDS bits, and they are a good deal heavier than an add on chuck,
but they drill ok.
--
Cheers,
John.
/================================================== ===============\
| Internode Ltd -
http://www.internode.co.uk |
|-----------------------------------------------------------------|
| John Rumm - john(at)internode(dot)co(dot)uk |
\================================================= ================/