On 19/07/2020 15:31, Mike McLeod wrote:
I only ask because I'm making up a controller for one. I don't find
the 3 heat settings provide enough choice so I'll be controlling a
small triac via a PWM chip. Although the max current draw of this
appliance is only 350mA, the triac (a Z0607) is pretty puny and I
don't want it operating at too close to its max ratings obviously. I'm
using a snubber to be on the safe side WRT to back EMF anyway.
Here's the datasheet for the triac:
https://www.st.com/resource/en/datasheet/z00607.pdf
Will that do it or is something more meaty required?
I'd say it was mostly resistive....
sure it's 'sort of' a coil - but a big flat one!
Can't comment on the suitability of the specific triac - I always like
to err on the cautious side and fit an over-rated component in
situations like this....