On 28/06/2020 8:15 pm, Phil Allison wrote:


Hi,

recently came across an SMD board with lots of chip resistors (0805) and similar size ceramic caps. There was mild surface corrosion on the ends of each resistor - enough to prevent a DMM from reading the value until cleaned with a "fibre pen". For the puzzled, it's an essential servicing tool.

https://www.ebay.com.au/itm/Fibregla...-/310094191492

The item itself looked new, but was in fact 9 years old.
Eventually I found 3 open resistors, all with values like 1Mohm.

Googling tells me this is a known hazard not shared with through hole parts - has to do with the use of silver plating on top surface of the resistor being subject to sulphiding and similar air borne contaminants.

Any insights?

**Also: Get yourself a pair of these:

https://www.wagneronline.com.au/4mm-...-test/6762/fl/

Pierces insulation (and fingers!) easily.


--
Trevor Wilson
www.rageaudio.com.au

--
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus